ROPA Tiger 6 - Adjusting Cutting Height - MT2

Operation
Defoliator
244 / 564
6.13.9.2 Adjusting cutting height - MT2
Scalper
Choose this function with R-Select. To facilitate setting
for you, the cutting depth can be read from the driver‘s
seat on a scale at the defoliator unit and on the R-Touch.
+ Key = cutting depth up = scalper support tube high
- Key = cutting height down = scalper bracing tube down
ADVICE
Information for persons familiar with the standard topper! The cutting height is set the
other way around with the MT2.