Operation
Defoliator
245 / 564
If the adjustment track of the cutting height adjustment from the driver’s seat is not
sufficient (e.g. if beets are sitting extremely high or extremely deep or in the case of
heavily worn scalper combs), this can be adjusted for such conditions by changing the
basic settings.
Please note when doing so, that the scalper bracing tube may not be lifted to a level
where the scalper flail no longer reaches the ground in the lowest setting.
If the scalper bracing tube is lifted higher, the scalper flail will no longer reach deeper
beets. These beets will not then be completely topped. For optimal topping results, the
scalper comb should be set so that the scalper bracing tube is located in the upper
half of the adjustment track during lifting.
Still less space must be here
To Next Page
Loading...