ROPA Tiger 6 - Selection of the Driving Direction (Forward+;Backward)

Operation
Driving
172 / 564
6.7.2 Selection of the driving direction (forward+/backward)
Foot switch driving direction (3):
NOT PRESSED driving direction „forward“
PRESSED driving direction „backward“
3
5
(3) Foot switch driving direction
(5) Drive pedal
ADVICE
For driving backward in the operating mode "Road", the drive pedal must be released
completely. Then, wait until the machine comes to a complete standstill (0.0 km/h).
Only then the foot switch "Driving direction" may be pushed and held in this position.
If the lifting unit is still lowered (i.e. the scalper is still on the ground), then an auto-
mated reversing block is in effect. This avoids damage which would otherwise be
caused by driving backward with the lifting unit lowered. The R-Touch displays the icon
.
To override the back run lock See Page 183
While driving backward, a warning signal sounds drawing attention of other people to
the reversing movement.