Maintenance and Service
Infeed conveyor gears
445 / 564
7.11 Infeed conveyor gears
Check oil level
Check the oil level of the infeed conveyor gears daily. The filling volume is sufficient if
the oil level reaches the inspection glass.
For this purpose:
Completely raise the lifter, then switch off the machine and secure it against inadver-
tent starting and rolling away. Fasten the safety chain left/right.
Change oil
Perform an oil change for the first time after 50 lifter operating hours, then annually.
Change the oil after the gear oil has reached operating temperature.
Lower the lifter completely down.
Let the oil drain through the oil drain opening (1) into an oil-resistant container of suffi-
cient size.
Turn the oil drain screw in again and tighten it. Carefully turn out the inspection glass.
Add fresh gear oil through the inspection glass opening (2) until the lower edge of the
opening has been reached.
Reinstall the inspection glass and use a new gasket (ROPA item no. 412026100).
Raise the lifter again.
Check the oil level.
Prescribed oil variants: Gear oil
API GL5, SAE 90
Filling volume: approx. 2.5 litres
To Next Page
Loading...