Maintenance and Service
Bunker
457 / 564
7.14.3.2 Retensioning longitudinal conveyor
The both longitudinal conveyors are tensioned in the front. They must be separately
retensioned. The two tightening bolts of each conveyor are located at the front, at the
conveyor turn around under the bunker floor.
(1) Tensioning bolt
(2) Lock nut
For retensioning:
– Loosen lock nuts (2).
– By screwing in the tensioning bolts (1), slide the conveyor guide roller forward until
the rear conveyor chains enter the guide bars again cleanly.
– Ensure that you adjust both tightening bolts (1) by the same distance each.
– Retighten lock nuts.
To Next Page
Loading...