Safety
Safety and health protection
32 / 564
355007700 (25)
Hazard that body parts can be pulled in. Do not reach into the rotating rollers. Do not climb
on the rollers. Never step into the loading areas when the drive activated and motor run-
ning.
355007800 (11)
Hazard of lowering
machine parts! Staying
in the hazard zone is
only admissible when the
safety lock for the lifting
cylinder is engaged.
355008000 (42)
Explosion hazard. The
pressure reservoir is
under very high pres-
sure. Perform removal
and repair only follow-
ing instructions from the
manual.
355006700 (44)
Never step in the hazard
area between attached
device and machine.
355006500 (37)
Falling hazard! Riding on
steps or platforms is pro-
hibited.
2.7 Safety and health protection
The stipulations and regulations listed below must be rigorously observed in order to
reduce the risk of personal injury and/or property damage. Furthermore, the region-
ally applicable regulations and instructions on safety at work and for safe handling of
self-propelled processing machines must be observed in any case. For safety rea-
sons, anyone working with the machine must have read and understood the operating
instructions. He must also be familiar with the applicable regulations on safety at work
and health protection regulations.
For safe operation of the machine, the applicable health protection regulations, the rel-
evant national work safety regulations or equivalently applicable national work safety
and health protection regulations of other member states of the European Union or
other states which have signed the agreement on the European Economic Area must
be rigorously applied.
The operator is obliged to provide the applicable regulations in their current versions
free of charge to the machine operator.
The machine may only be used for its intended purpose and in compliance with
these operating instructions.
The machine must be used and operated in such a manner that its stability is guar-
anteed at any time.
The machine may not be operated in enclosed rooms.
The effectiveness of operating and adjusting components may not be impaired or
overridden without approval.
To Next Page
Loading...