Operation
Infeed conveyor
294 / 564
6.15.4 Setting infeed conveyor – distance settings
In case of beet losses at the transition lifting roller/infeed conveyor/1st strainer wheel,
the front and rear distance of the infeed conveyor must be set as described below.
6.15.4.1 Setting infeed conveyor distance longitudinally
The distance between conveyor and the last lifting roller can be set in front at the lifter
on the left and right by turning the stop bolt (2) and self-locking nuts (1). To achieve
good soil separation and easy passage of foreign objects, the distance should always
be set as large as possible.
ATTENTION
Danger of machine damage.
Make sure that the conveyor in no case touches the lifting roller. This might cause
severe damage to the conveyor.
To Next Page
Loading...