Maintenance and Service
Bunker
460 / 564
7.14.3.5 Bearings of the conveyor drive shaft and cleaner roller
Longitudinal conveyors
The three drive shaft bearings must be lubricated every 100 operating hours. Two
bearings may be lubricated from inside the bunker through a hole (5) in the cover of
the longitudinal conveyor drive shaft. The third bearing is located on the drive shaft
behind the chain wheel (accessible with opened right protective cover).
Cross conveyors
The three drive shaft bearings (on the left side of the machine) must also be lubricated
every 100 operating hours. You can lubricate two bearings from within the bunker,
through a hole in the cover of the cross conveyor drive shaft. The rear bearing is
located on the drive shaft behind the chain wheel.
Lubricating nipples unit in engine compartment
To Next Page
Loading...