Operation
Diesel engine
157 / 564
6.5.1 Start/shut down diesel engine
If the drive pedal is not in resting position during starting, then for safety reasons, trac-
tion drive is blocked. The block remains for so long until the drive pedal is completely
released and pressed again.
ATTENTION
Danger of machine damage.
Use of chemical starting aids (e.g. Startpilot etc.) is expressly prohibited, because this
may lead to injuries and to damage to the machine.
The ignition lock has three switching positions:
Position 0: Shut down engine/ignition off – the key may be removed
Position I: Ignition on, the engine is ready for starting
Position II: Start engine (not connected)
The engine is started with the START key and shut down with the STOP key
.
If the engine does not start immediately, then the electronic system switches off the
starter after a certain period of time. In this case, wait at least 2 minutes until the next
try to start so that the starter can sufficiently cool down.
Help for engine starting See Page 509
To Next Page
Loading...