Maintenance and Service
Axles
414 / 564
DANGER
Injury hazard!
Hazard to life due to moving machine parts.
– Before oil change, each time stop the machine and switch off the engine.
– The machine must be secured against inadvertent starting of the engine.
– All maintenance and repair work may only be performed by trained personnel.
Proceed as follows for changing the oil:
– Clean before oil change wide area around the intake filter.
– Change the oil only with gears warm after operation.
– Park the machine on level ground.
– Put an oil-resistant collecting vessel of sufficient size underneath.
– Turn off the closing cap of the oil drain screw.
– Open the oil level filling screw and wait until the oil has drained completely.
– Remove the screw cap (5) of the intake hose from the filter connection.
– Exchange the filter element for a new one (ROPA item no. 181005400).
– Reinsert the oil drain screw.
– Open the oil filler screw and fill in fresh oil into the filler neck for so long, until the oil
level is in the upper range of the inspection glass.
– Screw the oil level control screw in again.
Prescribed oil variants: Fully synthetic gear oil
API GL5, SAE 75W-90 as per ZF stan-
dard TE-ML 05B
Filling volume: approx. 3 litres
To Next Page
Loading...