Ruckus Wireless Virtual SmartZone High Scale User Manual

TABLE 253 MAP downlink disconnected from MAP event (continued)
Event MAP downlink disconnected from MAP
Severity Informational
Attribute "secondMapMac"=" xx:xx:xx:xx:xx:xx", "apMac"="xx:xx:xx:xx:xx:xx"
Displayed on the web
interface
MAP [{secondMapName&&secondMapMac}] disconnected from MAP
[{apName&&apMac}]
Description This event occurs when the MAP disconnects from a second MAP.
RAP downlink disconnected from MAP
TABLE 254 RAP downlink disconnected from MAP event
Event RAP downlink disconnected from MAP
Event Type rapDlinkDisconnectWithMap
Event Code 427
Severity Informational
Attribute "secondMapMac"=" xx:xx:xx:xx:xx:xx", "apMac"="xx:xx:xx:xx:xx:xx"
Displayed on the web
interface
MAP [{secondMapName&&secondMapMac}] disconnected from RAP
[{apName&&apMac}]
Description This event occurs when the MAP disconnects from RAP.
AP State Change Events
Following are the events related to access point state changes.
Event
Event Event
AP rebooted by user on page 173 AP rebooted by system on page 173 AP disconnected on page 173
AP IP address updated on page 174 AP reset to factory default on page 174 AP channel updated on page 174
AP country code updated on page 175 AP channel updated because dynamic frequency
selection (DFS) detected a radar on page 175
AP change control plane on page 175
AP connected on page 176 AP deleted on page 176 AP heartbeat lost on page 176
AP tagged as critical on page 176 AP cable modem interface down on page 177 AP brownout on page 177
AP cable modem power-cycled by user on page
177
AP smart monitor turn off WLAN on page 178 AP client load balancing limit reached on page
178
AP client load balancing limit recovered on page
178
AP WLAN state changed on page 179 AP capacity reached on page 179
AP capacity recovered on page 179 AP cable modem interface up on page 180 AP cable modem soft-rebooted by user on page
180
AP cable modem set to factory default by user on
page 180
AP health high latency flag on page 181 AP health low capacity flag on page 181
AP health high connection failure flag on page
181
AP health high client count flag on page 182 AP health high latency clear on page 182
AP health low capacity clear on page 182 AP health high connection failure clear on page
183
AP health high client count clear on page 183
Primary DHCP AP is down on page 183 Primary DHCP AP is up on page 184 Secondary DHCP AP is down on page 184
Secondary DHCP AP is up on page 184 Primary or secondary DHCP AP detects 90% of
the configured total IPs on page 184
Both primary and secondary DHCP server APs
are down on page 185
Events Types
AP State Change Events
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
172 Part Number: 800-71565-001 Rev A

Ruckus Wireless Virtual SmartZone High Scale Specifications

General

Brand	Ruckus Wireless
Model	Virtual SmartZone High Scale
Category	Gateway
Language	English