AP Communication Alarms
Following are the alarms related to access point communications.
• AP rejected on page 65
• AP configuration update failed on page 65
• AP swap model mismatched on page 66
• AP pre-provision model mismatched on page 66
• AP firmware update failed on page 66
• AP WLAN oversubscribed on page 67
• AP join zone failed on page 67
AP rejected
TABLE 17 AP rejected alarm
Alarm AP rejected
Alarm Type apStatusRejected
Alarm Code 101
Severity Minor
Aggregation Policy From the event code 105 an alarm is raised for every event. A single event
triggers a single alarm.
Auto Clearance The alarm is auto cleared with the event code 103.
Attribute “apMac”=”xx:xx:xx:xx:xx:xx”, “wsgIP"=”xxx.xxx.xxx.xxx”, “reason”=”xxx”
Displayed on the web
interface
{produce.short.name} [{wsgIP}] rejected AP [{apName&&apMac}] because of
[{reason}]
Description This alarm is triggered when the AP is rejected.
Recommended Actions Check if the number of licenses has exceeded the limit. You would need to
purchase additional licenses, in case of insufficient licenses.
AP configuration update failed
TABLE 18 AP configuration update failed alarm
Alarm AP configuration update failed
Alarm Type apConfUpdateFailed
Alarm Code 102
Severity Major
fAggregation Policy From the event code 111 an alarm is raised for every event. A single event
triggers a single alarm.
Auto Clearance The alarm is auto cleared with the event code 110.
Attribute “apMac”=”xx:xx:xx:xx:xx:xx”, “configID”=”23456781234”
Displayed on the web
interface
AP [{apName&&apMac}] failed to update to configuration [{configID}]
Description This alarm is triggered when the controller is unable to update the AP
configuration details.
Alarm Types
AP Communication Alarms
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A 65
To Next Page
Loading...
Need help?
General
