Ruckus Wireless Virtual SmartZone High Scale User Manual

TABLE 120 License going to expire alarm (continued)
Alarm License going to expire
Description This alarm is triggered when the validity of the license is going to expire.
Recommended Actions Check the validity of licenses. You would need to purchase additional licenses if
validity expires.
Insufficient license capacity
TABLE 121 Insufficient license capacity alarm
Alarm Insufficient license capacity
Alarm Type apConnectionTerminatedDueToInsufficientLicense
Alarm Code 1256
Severity Major
Aggregation Policy From the event code 1256 an alarm is raised for every event. A single event
triggers a single alarm.
Attribute "licenseType”=“ xxx”
Displayed on the web
interface
Insufficient [{licenseType}] license is detected and it will cause existing AP
connections to terminate.
Description This alarm is triggered when connected APs are rejected due to insufficient
licenses.
Recommended Actions Check the number of licenses. You would need to purchase additional licenses
due to insufficient number of licenses.
NOTE
Refer to Licensing Interface Events on page 286.
PMIPv6 Alarms
NOTE
This section is not applicable for vSZ-H.
Following are the alarms related to PMIPv6.
• Config update failed on page 116
• LMA ICMP unreachable on page 117
• LMA failed over on page 117
• DHCP connection lost on page 118
Config update failed
TABLE 122 Config update failed alarm
Alarm Config update failed
Alarm Type updateCfgFailed
Alarm Code 5004
Severity Major
Alarm Types
PMIPv6 Alarms
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
116 Part Number: 800-71565-001 Rev A

Ruckus Wireless Virtual SmartZone High Scale Specifications

General

Brand	Ruckus Wireless
Model	Virtual SmartZone High Scale
Category	Gateway
Language	English