Cluster Alarms
Following are the alarms related to cluster.
• New node failed to join on page 78
• Node removal failed on page 79
• Node out of service on page 79
• Cluster in maintenance state on page 80
• Cluster backup failed on page 80
• Cluster restore failed on page 81
• Cluster upgrade failed on page 81
• Cluster application stopped on page 82
• Node bond interface down on page 82
• Node physical interface down on page 83
• Cluster node rebooted on page 83
• Cluster node shut down on page 83
• Disk usage exceed threshold on page 84
• Cluster out of service on page 84
• Cluster upload AP firmware failed on page 85
• Cluster add AP firmware failed on page 85
• Unsync NTP time on page 85
• Cluster upload KSP file failed on page 86
• Configuration backup failed on page 86
• Configuration restore failed on page 86
New node failed to join
TABLE 43 New node failed to join alarm
Alarm New node failed to join
Alarm Type newNodeJoinFailed
Alarm Code 801
Severity Critical
Aggregation Policy From the event code 803 an alarm is raised for every event. A single event
triggers a single alarm.
Auto Clearance The alarm code is auto cleared with the event code 802.
Attribute “clusterName”=”xxx”, “nodeName”=”xxx”,
“nodeMac”=” xx:xx:xx:xx:xx:xx”
Displayed on the web
interface
New node [{nodeMac}] ([{nodeName}]) failed to join cluster [{clusterName}]
Description This alarm is triggered when a node fails to join a cluster session. The web
interface displays the error message.
Recommended Actions When the operation fails, the user can run the join process. If it continues to fail,
please send the complete system log files (stored in the path -
Alarm Types
Cluster Alarms
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
78 Part Number: 800-71565-001 Rev A
To Next Page
Loading...
