AP NAT failure
TABLE 32 AP NAT failure alarm
Alarm AP cable modem interface down NAT failure detected by controller due to three
(3) consecutive NAT gateway APs are down
Alarm Type apNATFailureDetectedbySZ
Alarm Code 346
Severity Major
Aggregation Policy From the event code 346 an alarm is raised for every event. A single event
triggers a single alarm.
Attribute ”apMac1”=“xx:xx:xx:xx:xx:xx”, ”apMac2”=“xx:xx:xx:xx:xx:xx”, ”apMac3”=“xx:xx:x
x:xx:xx:xx”
Displayed on the web
interface
NAT failure detected by SZ since three (3) consecutive NAT gateway IPs are
down AP1=[{apMac1}] AP2=[{apMac2}] AP3=[{apMac3}] (All consecutive NAT
APs are down in case of less than 3 NAT Gateway APs configured). The NAT
traffic for some of the clients may get affected for the respective VLANs.
Description This alarm is triggered when the controller detects three (3) consecutive failures of
NAT server APs.
NOTE
Refer to AP State Change Events on page 172.
Authentication Alarms
The following are the alarms related to authentication.
• Authentication server not reachable on page 72
• Authentication failed over to secondary on page 73
• Authentication fallback to primary on page 73
• AD/LDAP connectivity failure on page 74
• Bind fails with AD/LDAP on page 74
• Bind success with LDAP, but unable to find clear text password for the user on page 75
• RADIUS fails to connect to AD NPS server on page 75
• RADIUS fails to authenticate with AD NPS server on page 76
• Fails to establish TLS tunnel with AD/LDAP on page 76
Authentication server not reachable
TABLE 33 Authentication server not reachable alarm
Alarm Authentication server not reachable
Alarm Type authSrvrNotReachable
Alarm Code 1601
Severity Major
Aggregation Policy From the event code 1601 an alarm is raised for every event. A single event
triggers a single alarm.
Alarm Types
Authentication Alarms
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
72 Part Number: 800-71565-001 Rev A
To Next Page
Loading...
Need help?
General
