Ruckus Wireless Virtual SmartZone High Scale User Manual

TABLE 64 AP configuration generation failed alarm (continued)
Alarm AP configuration generation failed
Displayed on the web
interface
Failed to generate configuration for [{apCfgGenFailedCount}] AP(s) under
zone[{zoneName}]
Description This alarm is triggered when the controller fails to generate the AP configuration
under a particular zone.
Recommended Actions APs under these zone stay functional but are unable to receive the new settings.
Contact Ruckus support to file an error bug along with the log file.
End-of-life AP model detected
TABLE 65 End-of-life AP model detected alarm
Alarm End-of-life AP model detected
Alarm Type cfgGenSkippedDueToEolAp
Alarm Code 1023
Severity Major
Aggregation Policy From the event code 1023 an alarm is raised for every event. A single event
triggers a single alarm.
Attribute “nodeMac”="50:A7:33:24:E7:90","zoneName"="openZone","model"="R300,T30
0"
Displayed on the web
interface
Detected usage of end-of-life ap model(s)[{model}] while generating configuration
for AP(s) under zone[{zoneName}]
Description This alarm is triggered when the controller detects the AP model’s end-of-life
under a certain zone.
Recommended Actions These obsoleted APs occupies licensed AP space. Disconnect these
unsupported AP models from the given zone by:
• Reset the APs to a factory setting using the AP command line
• Delete these APs through the controller Web Interface > Configuration
AP List
NOTE
Refer to Configuration Events on page 240.
VLAN configuration mismatch on non DHCP/NAT WLAN
TABLE 66 VLAN configuration mismatch on non DHCP/NAT WLAN alarm
Alarm VLAN configuration mismatch detected between configured and resolved VLAN
with DVLAN/VLAN pooling configuration on non-DHCP/NAT WLAN
Alarm Type apCfgNonDhcpNatWlanVlanConfigMismatch
Alarm Code 1024
Severity Critical
Aggregation Policy From the event code 1023 an alarm is raised for every event. A single event
triggers a single alarm.
Attribute “ssid”=”xxxx”, “wlanID”=”xxxx”, “configuredVlan”=”5”
Displayed on the web
interface
DHCP/NAT gateway AP [{apMac}] detected VLAN configuration mismatch on
non-DHCP/NAT WLAN [{ssid}]. Configured VLAN is [{configuredVlan}] and
resolved VLAN is [{vlanId}]. Clients may not be able to get IP or access Internet.
Alarm Types
Configuration Alarms
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
88 Part Number: 800-71565-001 Rev A

Ruckus Wireless Virtual SmartZone High Scale Specifications

General

Brand	Ruckus Wireless
Model	Virtual SmartZone High Scale
Category	Gateway
Language	English