Ruckus Wireless Virtual SmartZone High Scale - The Number of Devices Exceeded Its Limit; Tunnel Events - Access Point (AP)

TABLE 698 The number of users exceed its limit event (continued)
Event The number of users exceed its limit
Severity Major
Attribute No attributes for this event.
Displayed on the web
interface
The number of users exceeded its limit.
Description This event occurs when the number of users exceeds the specified limit. The
threshold limit for SCG-200 and vSZ-H is 950000.
The number of devices exceeded its limit
TABLE 699 The number of devices exceeded its limit event
Event The number of devices exceeded its limit
Event Type tooManyDevices
Event Code 7002
Severity Major
Attribute No attributes for this event.
Displayed on the web
interface
The number of devices exceeded its limit
Description This event occurs when the number of devices exceeds the specified limit. The
threshold limit for SCG-200 and vSZ-H is 2850000.
NOTE
Refer to Threshold Alarms on page 135.
Tunnel Events - Access Point (AP)
Following are the events related to tunnel events on access point.
• Data plane accepted a tunnel request on page 332
• Data plane rejected a tunnel request on page 332
• Data plane terminated a tunnel on page 332
• AP created a tunnel on page 332
• AP tunnel disconnected on page 333
• AP softGRE tunnel fails over primary to secondary on page 333
• AP softGRE tunnel fails over secondary to primary on page 333
• AP softGRE gateway reachable on page 334
• AP softGRE gateway not reachable on page 334
• Data plane set up a tunnel on page 334
• AP secure gateway association success on page 335
• AP is disconnected from secure gateway on page 335
• AP secure gateway association failure on page 335
NOTE
Event codes 601 to 610 are not applicable for vSZ-H.
Events Types
Tunnel Events - Access Point (AP)
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
Part Number: 800-71565-001 Rev A 331