TABLE 23 AP join zone failed alarm (continued)
Alarm AP join zone failed
Attribute "apMac"=”xx:xx:xx:xx:xx:xx”, "zoneUUID"=”xx:xx:xx:xx:xx:xx”,
"targetZoneUUID"=”xx:xx:xx:xx:xx:xx”, "reason"=”xx:xx:xx:xx:xx:xx”
Displayed on the web
interface
AP [{apName&&apMac}] failed to join to zone [{targetZoneName}]. Reason:
[{reason}]
Description This alarm is triggered when the AP fails to join the specified zone
Recommended Actions Check if the number of RXGW (AP direct tunnel license) licenses has exceeded
the limit. You would need to purchase additional licenses, in case of insufficient
licenses.
NOTE
Refer to AP Communication Events on page 154.
AP LBS Alarms
Following are the alarms related to AP Location Based Service (LBS).
• No LS responses on page 68
• LS authentication failure on page 68
• AP failed to connect to LS on page 69
No LS responses
TABLE 24 No LS responses alarm
Alarm No LS responses
Alarm Type apLBSNoResponses
Alarm Code 701
Severity Major
Aggregation Policy From the event code 701 an alarm is raised for every event. A single event
triggers a single alarm.
Attribute “apMac”=“xx:xx:xx:xx:xx:xx“, “url”=““,”port”=““
Displayed on the
SmartZone web interface
AP [{apName&&apMac}] no response from LS: url=[{url}], port=[{port}]
Description This alarm is triggered when the AP does not get a response when trying to
connect to the location based service.
Recommended Actions This alarm is triggered when the location server fails to respond to the AP request
due to an error or the server is a maintenance mode. Report this to the location
server owner.
LS authentication failure
TABLE 25 LS authentication failure alarm
Alarm LS authentication failure
Alarm Type apLBSAuthFailed
Alarm Code 702
Alarm Types
AP LBS Alarms
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
68 Part Number: 800-71565-001 Rev A