TABLE 224 Classified Rogue AP event (continued)
Event Classified Rogue AP
Severity Warning
Attribute "apMac"="xx:xx:xx:xx:xx:xx", "rogueMac""=""xxx.xxx.xxx.xxx",
"ssid""="xxxxxxxxxx", "channel"="xx", "rogueType"="xxxxx",
"roguePolicyName"="xxxxx", "rogueRuleName"="xxxxx"
Displayed on the web
interface
AP [{apName&&apMac}] has detected a rogue AP rogue AP[{rogueMac}] with
SSID[{ssid}] on channel[{channel}] classified as [{rogueType}] because of rogue
classification policy (policy[{roguePolicyName}], rule[{rogueRuleName}]).
Description This event occurs when the AP detects a rogue AP(malicious/known) that is
classified by configurable rogue policy and its rules.
AP image signing failed
TABLE 225 AP image signing failed event
Event AP image signing failed
Event Type apSigningInformation
Event Code 187
Severity Informational
Attribute "apMac"="xx:xx:xx:xx:xx:xx"
Displayed on the web
interface
The AP[{apMac}] image signing failed with firmware version [{fwVersion}].
Description This event occurs when an AP image signing fails.
NOTE
Refer to AP Communication Alarms on page 65.
AP LBS Events
The following are the events related to AP Location Based Service (LBS).
• No LS responses on page 163
• LS authentication failure on page 163
• AP connected to LS on page 163
• AP failed to connect to LS on page 163
• AP started location service on page 164
• AP stopped location service on page 164
• AP received passive calibration request on page 164
• AP received passive footfall request on page 165
• AP received unrecognized request on page 165
Events Types
AP LBS Events
Ruckus SmartCell Gateway 200 Virtual SmartZone High Scale and SmartZone 300 Alarm and Event Reference Guide
162 Part Number: 800-71565-001 Rev A
To Next Page
Loading...
Need help?
General
