To open the NTP Setup screen, navigate to MANAGEMENT > NTP Setup. The NTP Setup screen
is divided into 5 panels:
Note: The panels will be disabled if you applied the optional TimeKeeper license,
and enabled TimeKeeper (MONITORING > TimeKeeper Service).
The NTP Servers and Peers panels
… are located on the right-hand side of the NTP screen:
NTP Servers: In this display you can view the NTP Servers that SecureSync detects in your
network. It is through this display that you configure external NTP references. See "NTP
Servers: Adding, Configuring, Removing" on page107.
NTP Peers: In this display you can view the NTP Peers that SecureSync detects in your net-
work. It is through this display that you configure NTP Peer reference inputs. See "NTP
Peers: Adding, Configuring, Removing" on page109.
For more information on NTP servers, clients, and Stratums see "NTP Servers and Peers" on
page104.
96
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
2.14 Configuring NTP
To Next Page
Loading...
