Spectracom SecureSync User Manual

Figure 2-2: IFF Autokey configuration example
Configuring NTP Autokey
Note: When you configure NTP Autokey, you must disable the NTP Service first,
and then re-enable it after Autokey configuration is completed. See "Dis-/En-
abling NTP" on page98.
To configure NTP Autokey:
2.14 Configuring NTP
CHAPTER 2 • SecureSync User Reference Guide Rev. 26
113

Spectracom SecureSync Specifications

General

Model	SecureSync
Time Reference	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Disciplines	GNSS, IRIG, PTP, NTP, SyncE
Inputs	GPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
Outputs	NTP, PTP, 1PPS, IRIG
Protocols	PTP, NTP, SNMP, SSH, HTTPS
Form Factor	1U Rack-mount
Redundancy	Optional redundant power supply
Security Features	Password protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply	100-240 VAC, 50-60 Hz
Operating Temperature	0°C to +50°C
Dimensions	44.45 mm (H) x 482.6 mm (W)