EasyManuals Logo

Spectracom SecureSync User Manual

Spectracom SecureSync
599 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
4.
To enable OSPF IPv4 Anycast, check Enable under the OSPF tab. To enable OSPF IPv6
Anycast, check Enable under the OSPF6 tab. To enable BGP Anycast, check Enable
under the BGP tab. Then click Submit.
When the NTP Anycast Expert Mode window is opened, the files displayed are the con-
figuration files in their current states. If no configuration was done outside of Expert Mode,
these will be the factory default files. If Anycast configuration was already done from the Web
UI, you will be able to edit the existing Anycast setup.
When editing zebra.conf in expert mode, you should ensure that the first line under an
interface line is an ip address line declaring an IPv4 address (if there is one for the inter-
face), and that the next line is an ipv6 address line declaring an IPv6 address (if there is
one for the interface). No other lines or variations in spacing should be inserted before or
between these lines. No editing restrictions exist on ospfd.conf or ospf6d.conf files.
Example zebra.conf file with both IPv4, and IPv6 configured on the same port:
(Interface eth0 line, followed by IPv4 line and then IPv6 line)
*****************************************************
!
interface eth0
ip address 10.2.100.157/16
ipv6 address 2000:10:2::157/64
!
interface lo
ip address 10.10.14.1/32
ipv6 address 2000:10:10::1/64
*****************************************************
Example zebra.conf file with IPv4, and IPv6 configured on different ports:
(Interface eth0 line, followed by only IPv4 line, because no IPv6 address is configured on that
port. Interface eth1 line, followed by only IPv6 line, because no IPv4 address is configured on
that port)
*****************************************************
!
interface eth0
ip address 10.2.100.157/16
interface eth1
ipv6 address 2000:10:2::157/64
!
interface lo
ip address 10.10.14.1/32
ipv6 address 2000:10:10::1/64
128
CHAPTER 2 SecureSync User Reference Guide Rev. 26
2.14 Configuring NTP

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Spectracom SecureSync and is the answer not in the manual?

Spectracom SecureSync Specifications

General IconGeneral
ModelSecureSync
Time ReferenceGPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
DisciplinesGNSS, IRIG, PTP, NTP, SyncE
InputsGPS, GLONASS, BeiDou, Galileo, IRIG, NTP, PTP, 1PPS
OutputsNTP, PTP, 1PPS, IRIG
ProtocolsPTP, NTP, SNMP, SSH, HTTPS
Form Factor1U Rack-mount
RedundancyOptional redundant power supply
Security FeaturesPassword protection, access control lists, SSH, HTTPS, SNMPv3, NTP authentication, PTP authentication
Power Supply100-240 VAC, 50-60 Hz
Operating Temperature0°C to +50°C
Dimensions44.45 mm (H) x 482.6 mm (W)

Related product manuals