1.
Navigate to MONITORING > BroadShield.
2.
In the BroadShield Service panel on the left, configure the desired setting:
Note: Turning BroadShield OFF and Auto Sync Control ON is an invalid
setting and will cause a "Failed to connect to the unit..." error.
3.
In the BroadShield Web UI on the right, navigate to SETTINGS > ALGORITHMS, and
ensure that Jamming and/or Spoofing detection are enabled.
Configuring BroadShield
To configure BroadShield:
1.
Navigate to MONITORING > BroadShield. (If you cannot see the MONITORING button
in the Primary Navigation Bar of the HOMEscreen, this license is not present.) The
embedded Broadshield Web UI will open.
2.
Click SETTINGS to open the following sub-menus:
BROADSIGHT
BroadSight is a service that allows collection of data from multiple BroadShield units and
provides a dashboard view of the data.
Note: BroadSight for SecureSync is currently not supported.
176
CHAPTER 3 • SecureSync User Reference Guide Rev. 26
3.3 Managing References
To Next Page
Loading...
