Symmetricom TimeProvider 5000 User Manual

110 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show clock
Displays the date, time, and leapseconds in several formats.
– Current IMC time as a date and time
– Current IOC time as a date and time
– Accumulated leapseconds between TAI and UTC time
– Pending leapseconds
Command Syntax:
show clock
Example:
tp5000> show clock
Response 1:
IMC time: 2009-06-09 22:35:24
IOC time: 2009-06-09 22:35:24
Leap sec: 34
Leap pend: 0
Response 2:
When the ToD source is GPS, and the system has never been locked to GPS, the
response will be as follows:
IMC time: 2009-06-09 22:35:24 (not validated)
IOC time: 2009-06-09 22:35:24 (not validated)
Leap sec: 34
Leap pend: 0
Level : User, Config, and Admin
set clock
Provisions the user-assigned Date, Time, and accumulated leapseconds. The
reference mode must be set to the frequency mode with the
set ref mode
frequency
command in order to change any clock settings.
Command Syntax:
 To set the Date and Time 
set clock date-time <date-time>

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English