Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 365
Chapter 5 Operating
Managing PTP Clients
Managing PTP Clients
The TimeProvider 5000 GrandMaster supports four different aspects of PTP
management for TimeProvider 500 clients. The “set ptp-node” command is used to
provision the acceptable master clocks, reboot, and upgrade the firmware for TP500
clients through the TP5000 GrandMaster. See Figure 5-2. The “show ptp-node
status” command is used to monitor TP500 client performance. The TimeProvider
5000 also offers a means to monitor alarm and event information for TimeProvider
500 clients using Simple Network Management Protocol (SNMP).
Figure 5-2. PTP Management Commands

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English