EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #364 background imageLoading...
Page #364 background image
364 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 5 Operating
Restarting the TimeProvider 5000
Example
1. Type
show log event and press Enter.
Restarting the TimeProvider 5000
The system can be restarted via the reboot system command. Since reference
output signals will be lost, it is not recommended to restart the entire system unless
required. Only the admin user can issue the reboot command. The
reboot imc
command restarts the IMC card, and no output will be lost. If the system has two
IOC modules, each IOC can be rebooted separately to preserve the output.
Example:
1. Type
reboot imc and press Enter.
2. Type
reboot ioc1 and press Enter.
3. Type
show status and press Enter to check the status of IOC1.
4. After IOC1 has entered the standby state, type
reboot ioc2 and press Enter (if
applicable).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals