EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #510 background imageLoading...
Page #510 background image
510 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Appendix F PTP Probe Option
Provisioning the Probe
See Chapter 2 of the TP 5000 Users Guide for Installation details. See Chapter 4 of
the TP 5000 Users Guide for details about provisioning the TP 5000 using CLI
commands.
Enable the Probe Option on the TP 5000
The probe option must be enabled with the Symmetricom authentication key in
order to use the TP 5000 as a probe.
Use the show license command to check if the probe option has been enabled yet
for the TP 5000. Use the set license command to enter the authentication key for
Example:
To enable the probe option with an authentication key of
“ABCDEFGHIJ1234567890KLMNOPQRST0987654321”:
tp5000> set license add
The TP 5000 will prompt for the license key:
License key: ABCDEFGHIJ1234567890KLMNOPQRST0987654321,
Note: The default IP address for the IMC MGMT port of the TP
5000 is:
IP Address:
192.168.0.100
Gateway: 0.0.0.0
Netmask: 255.255.255.0
Note: The unit’s default user name is “admin” and the default
password is “
symmadmin**”.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals