EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #315 background imageLoading...
Page #315 background image
098-00028-000 Revision F – May, 2012 TimeProvider 5000 Users Guide 315
Chapter 4 Provisioning
Provisioning the Input Reference
Setting GNSS Port as Reference
To provision the TimeProvider 5000 for GNSS, use the set ref mode time
command to select a Time mode. Use the
set gnss command to provision the
GNSS port state and GNSS parameters.
Track-Mode
The Priority setting for GNSS is for the GNSS port itself. However, the GNSS port
for the 090-50331-04 can receive Beidou and GPS satellite RF inputs. (Future
implementations of the IMC card may support RF inputs from other satellites.) The
GNSS track-mode parameter is used to specify the tracking priority for the GNSS
port.
GPS: Only checks for qualified GPS on this port
Beidou: Only checks for qualified Beidou on this port
Priority-beidou: Checks for qualified Beidou signal before checking for GPS
Priority-gps : Checks for qualified GPS signal before checking for Beidou
Figure 4-21. Set GNSS Command Hierarchy
Example
Note: Manual mode should not be used unless antenna location has
been accurately surveyed. See the
set gnss command description
for for details about setting GNSS position parameters manually.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals