Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 281
Chapter 4 Provisioning
Provisioning the Ethernet Ports
Figure 4-1. Set IP-Mode Command
Example
1. Login at the Admin or Config-user level (see Logging In, on page 275).
2. Type
set ip-mode imc dhcp and press Enter.
3. Type
set ip imc restart and press Enter.
Static IP Mode
Use the following procedure to configure the TimeProvider 5000 IP parameters
(Host Address, Subnet Mask, and Gateway Address) in Static IP mode on the
MGMT port. Use the dot-decimal notation format xxx.xxx.xxx.xxx to enter the
address parameter. See Figure 4-2.
Example
1. Login at the Admin or Config-user level (see Logging In, on page 275).
2. Type
set ip-mode imc static and press Enter.
3. Type
set ip imc address 192.168.0.10 netmask 255.255.255.0 gateway
192.168.0.1
and press Enter.
4. Type
set ip imc restart.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English