EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #328 background imageLoading...
Page #328 background image
328 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 4 Provisioning
Provisioning the Programmable E1/T1 Outputs
4. Type set output ssm port1 disable and press Enter.
5. Type
set output state port1 enable and press Enter.
D4 Frame Type
To provision Port 2 as an output port with a frametype of D4, SSM disabled, and to
enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port2 output and press Enter.
3. Type
set output frametype port2 d4 and press Enter.
4. Type
set output ssm port2 disable and press Enter.
5. Type
set output state port2 enable and press Enter.
ESF Frame Type
To provision Port 2 as an output port with a frametype of ESF, SSM enabled,
SSM-bit of 6, and to enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port2 output and press Enter.
3. Type
set output frametype port2 esf and press Enter.
4. Type
set output ssm port2 enable and press Enter.
5. Type
set output ssm-bit port2 6 and press Enter.
6. Type
set output state port2 enable and press Enter.
Provisioning Output Generation Behavior
The behavior of the output ports during warm-up, free-run, and holdover states can
be provisioned using the “set output warm-up”, “set output free-run”, and “set output
holdover” commands, as shown in Figure 4-25.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals