098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 239
Chapter 3
TimeProvider 5000 CLI Command Set
show snmp
Use these commands to display the SNMP Manager assigned to the agent, all
assigned users (username only), and the SNMP trap version and SNMP trap user.
Command Syntax:
To display the SNMP manager assignment:
show snmp manager
To display the SNMPv3 user configuration:
show snmp user
To display the SNMP TRAP user information (user names only):
show snmp trapuser
To display the SNMP v2-community information:
show snmp v2-community
To display the SNMP TRAP version information:
show snmp trapversion
To display the SNMP V2 state:
show snmp state-v2
To display the SNMP trap MIB has been selected:
show snmp trap-mib
To display which SNMP MIB version, 1.2 or 2.0, has been selected:
show snmp sys-obj-mib
Example 1:
tp5000> show snmp manager
Response 1:
-----------------------------------------------------------------------------
|Index|Manager ID |Manager Addr |Engine ID |
|-----|---------------|--------------------|--------------------------------|
|1 |m192.168.5.187 |192.168.5.187 |0x63000000a1c0a805bb |
|.....|...............|....................|................................|
|2 |m192.168.5.144 |192.168.5.144 |0x0123456789010384 |
|.....|...............|....................|................................|
|3 |m192.168.5.171 |192.168.5.171 |0x63000000a1c0a805bb |
|-----------------------------------------------------------------------------
Example 2:
tp5000> show snmp user