Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 247
Chapter 3
TimeProvider 5000 CLI Command Set
Remarks :See Table 3-4 below for IOC Clock Status descriptions.
Level : User, Config, and Admin
Table 3-4. IOC Clock Status
IOC Clock
Status
Description
Possible Next
State
Conditions Required
for Next Transition
State
Warmup This IOC is warming up. Freerun Ref mode = frequency
Warm-up complete
Fast-track Ref mode = time
GPS qualified
Warm-up complete
Freerun This IOC is operating
without a reference
Freerun Ref mode changed from
frequency to time
Fast-track Input becomes qualified
Fast-track This IOC has a qualified
input and clock is
stabilizing.
Bridging This IOC no longer has a
qualified input.
Normal-track Clock stabilized
Normal This IOC has a qualified
input and meets all
specifications.
Fast-track Clock not stabilized
adequately
Bridging This IOC no longer has a
qualified input.
Bridging This IOC no longer has a
qualified reference, but
remains operating within
specification associated
with normal_track
operation.
Holdover Bridging time exceeded
Fast-track Input reference
re-qualified in less than
bridging time.
Holdover This IOC no longer has a
qualified reference
Fast-track Input becomes qualified
See Note below.
Fail Hardware failure detected
on this IOC
none N/A

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English