Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 515
Appendix F PTP Probe Option
Provisioning the Probe
Table F-7. Set Probe IP Address Procedures
TimeMonitor PDV CLI Command
1. Click on the Command radio button to put
TimeMonitor PDV into the proper mode for
making Probe changes.
2. Click the Login button to login to the Probe. The
Probe will prompt for Username and Password.
3. Select the desired Probe port using the radio
buttons .
4. Enter the desired IP address, Netmask and
Gateway for the selected Probe port
5. Enter the Clock ID for the selected Probe port.
(optional).
Use the show ptp-probe
command to find the clock ID.
6. Click the Probe Address button to send the
address information to the Probe.
7. Repeat steps 3 through 6 for the other port.
Use the command:
set ip IOC1-x address
<addr_value> netmask
<mask_value> gateway <gateway
value>
Example - Independent Probe Ports:
1. Login at the admin or Config-user
level.
2. Type set ip ioc1-1 address
192.168.1.10 netmask
255.255.255.0 gateway
192.168.2.1 and press Enter.
3. Type set ip ioc1-2 address
192.168.2.12 netmask
255.255.255.0 gateway
192.168.2.1 and press Enter.
4. Type set redundancy port ioc1
disable and press Enter.
Note: It is possible to set the TP 5000 for
redundant probe ports, but this
configuration is not recommended.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English