Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 399
Chapter 6 Maintenance and Troubleshooting
TimeProvider 5000 Part Numbers
See Table 6-6 for the minimum firmware revisions required for TP 5000 hardware.
Compatibility Matrix
Table 6-6 below describes the minimum firmware revision required for TP 5000
hardware. The IMC, IOC and expansion shelves should all contain the same
firmware revision (see
Upgrading the Firmware, on page 389)..
Table 6-6. Compatibility Matrix - TP5000 Hardware and Firmware
Description P/N HW Rev.
Minimum
FW Rev.
Notes
IMC Module 090-50331-01 Rev L or higher 1.2.3 This module can’t
distinguish between
090-50301-01 and
090-50301-02 chassis.
Rev K or lower 1.0.6 This module can’t
distinguish between
090-50301-01 and
090-50301-02 chassis.
090-50331-02 2.0.4*
090-50331-04 2.0.4*
090-50331-05 2.0.4*
IMC Module - NTP 090-50332-01 2.0.4* This module can’t
distinguish between
090-50301-01 and
090-50301-02 chassis.
I/O Module 090-50311-01 1.0.6**
090-50312-01 1.0.6**
090-50314-01 1.2.3**
090-50315-01 2.0.4*, ** Should be used w/
090-50301-02 chassis
IOC Module, Quartz 090-50321-01 Rev L or higher 1.2.3
Rev K or lower 1.0.6
IOC Module, Rubidium 090-50322-01 Rev M or higher 1.2.3
Rev L or lower 1.0.6
Main Chassis 990-50301-01 1.0.6
Main Chassis 990-50301-02 2.0.4* Chassis can be used by
older firmware, but p/n
can't be identified by
"show inventory"

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English