Symmetricom TimeProvider 5000 User Manual

226 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show ptp-probe
This command is used to begin PTP packet measurements. This command can also
be used to display the Probe configuration, which includes Grandmaster Clock ID, IP
address and VLAN (if applicable), interval rate, and lease duration.
Command Syntax:
 To display the probe configuration data:
show ptp-probe config ioc1-[y]
 To begin gathering data with the probe:
show ptp-probe data ioc1-[y]
where
y= 1|2, the port number on IOC1
To stop gathering data with the probe, press the Enter key.
Example 1:
To display the configuration data of the Probe on port 2
tp5000> show ptp-probe config ioc1-2
Example 2:
To display the test data from port 1 of the Probe 
tp5000> show ptp-probe data ioc-1
Response :
F,00011,1229541029,099868364,1229541029,099881920,0000000000,
B,00011,1229541029,562553320,1229541029,562539700,0000000000,
F,00012,1229541030,099868364,1229541030,099881776,0000000000,
B,00012,1229541030,562553320,1229541030,562539700,0000000000,
F,00013,1229541031,099868364,1229541031,099881936,0000000000,
B,00013,1229541031,562553288,1229541031,562539700,0000000000,
F,00014,1229541032,099868364,1229541032,099881776,0000000000,
B,00014,1229541032,562553288,1229541032,562539700,0000000000,
Level : User, Config and Admin
Note: The Probe option must be purchased to enable the
functionality of all “ptp-probe” commands.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English