Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 309
Chapter 4 Provisioning
Provisioning NTP
Provisioning an IOC Port as NTP Server
Use the following procedure to configure and enable Port 2 of IOC1 as an NTP
server, with DSCP enabled, a DSCP value of 64 and TTL value of 25:
1. Login at the Admin or Config-user level.
2. Type
show ntp config ioc-2 to check current NTP status.
3. Type
set packet-service ioc1-2 ntp-server and press Enter.
4. Type
set ntp dscp-state ioc1-2 enable and press Enter.
5. Type
set ntp dscp ioc1-2 64 and press Enter.
6. Type
set ntp ttl ioc1-2 25 and press Enter.
7. Type
set ntp state ioc1-2 enable and press Enter.
8. Type
show ntp config ioc-2 to verify the changes.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English