Symmetricom TimeProvider 5000 User Manual

322 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 4 Provisioning
Provisioning the Programmable E1/T1 Inputs
8. Type set input state port2 enable and press Enter.
CAS Frame Type
To provision Port 2 as an input port with a frametype of CAS, with CRC enabled,
SSM enabled, SSM-bit of 7, Priority value of 1, and enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port2 input and press Enter.
3. Type
set input frametype port2 cas and press Enter.
4. Type
set input crc port2 enable and press Enter.
5. Type
set input ssm port2 enable and press Enter.
6. Type
set input ssm-bit port2 7 and press Enter.
7. Type
set input priority port2 1 and press Enter.
8. Type
set input state port2 enable and press Enter.
Provisioning T1 Inputs
Use the following procedures to provision I/O-1 or I/O-2 (RJ-48 ports) as a T1 input
(applies only to I/O module 090-50314-01).
1544kHz Frame Type
To provision Port 1 as an input port with a frametype of 1544kHz, SSM disabled, a
Priority value of 1, and to enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port1 input and press Enter.
Note: Disabling the input port will clear all alarms and events related
to this port.
Note: The T1 ports on the 090-50314-01 version of the I/O
module
can also be configured as E1 and 2048 kHz inputs or outputs
which meet the G.703 mask for impedance of 120 ohms, balanced.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English