Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 177
Chapter 3
TimeProvider 5000 CLI Command Set
show ntp
This command displays the NTP configuration and status data for Ethernet
interfaces on the IOC module. Configuration data includes state, DSCP state and
value, TTL value and VLAN ID. Status data includes state, version, mode, leap
status, stratum level, root dispersion and packet load..
Command Syntax:
 To show the NTP configuration of the specified port:
show ntp config ioc-x
 To show the NTP status of the specified port:
show ntp status ioc-x
Example 1:
To display NTP configuration of the port 1 Ethernet interface on the IOC module 
tp5000> show ntp config ioc-1
Response 1:
NTP State enabled
NTP DSCP 0
NTP DSCP State disabled
NTP TTL 64
NTP VLAN Id 2
NTP Packet Limit 20000
Example 2:
To display NTP status of the port 1 Ethernet interface on the IOC module 
tp5000> show ntp status ioc-1
Response 2:
Port enabled: yes
Version: 4
Mode: server
Leap status: no warning
Stratum level: 1
Root dispersion: 0.0 sec
Packet load: 5%
Level : User, Config, and Admin

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English