EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #306 background imageLoading...
Page #306 background image
306 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 4 Provisioning
Provisioning PTP
Figure 4-16. Two-Step Clock
Table 4-13. PTP
Unicast Static Addressing Mode Parameter Descriptions
Parameter Description
state Use to enable or disable Unicast - Static mode on the TP5000
on the specified port.
address Sets the static IP address for a client for the specified port.
clock-id Use to enter the clock ID for the specified client.
vlanid Use to enter the VLAN ID to be used for the specified client on
the specified port. The VLAN must configured and enabled in
order to use this. (See Provisioning VLAN, on page 287)
sync-int Sets the synchronization interval for the TP5000 Grandmaster,
how often to send synchronization messages (T1) to clients on
the specified port.
The interval is 2
z
seconds, where z= <sync-int-value>.
announce-int Sets the announce interval for the TP5000 Grandmaster, how
often to send announce messages to clients on specified port.
The interval is 2
z
seconds, where z= <announce-int-value>.
delay-int Sets the delay interval for the TP5000 Grandmaster, how often
to expect to receive delay request messages (T3 - T4) from
clients on the specified port.
The interval is 2
z
seconds, where z= <delay-limit-value>.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals