EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #305 background imageLoading...
Page #305 background image
098-00028-000 Revision F – May, 2012 TimeProvider 5000 Users Guide 305
Chapter 4 Provisioning
Provisioning PTP
Table 4-11. PTP
Multicast Addressing Mode Parameter Descriptions
Parameter Description
client-timeout Sets the client timeout value. If less than several hundred delay
request messages have been received from a client before the
specified client timeout value, the Grandmaster removes that client
from the client list. If delay requests are sent at a slow rate, then the
client-timeout value must be increased.
Applies to Default (Multicast) and Hybrid (Multicast-Hybrid) ptp
profiles.
announce-timeout Sets the announce timeout value for Multicast address mode. This
should be set to a consistent value in the PTP domain.
vlanid Sets the VLAN ID for the Grandmaster in Multicast address mode.
A VLAN ID of 0 is used to specify that no VLAN is being used. Only
one VLAN will be supported in Default (Multicast) and Hybrid PTP
profiles.
announce-int Sets the announce interval for the TP5000 Grandmaster, how often
to send announce messages to clients on the specified port.
Applies to Default (Multicast) and Hybrid PTP profiles
The interval is 2
z
seconds, where z= <announce-int-value>.
sync-int Sets the synchronization interval for the TP5000 Grandmaster, how
often to send synchronization messages to clients on the specified
port. Applies to Default (Multicast) and Hybrid PTP profiles.
The interval is 2
z
seconds, where z= <sync-int-value>.
delay-int Sets the delay interval for the TP5000 Grandmaster, how often to
send delay response messages to clients on the specified port.
Applies to Default (Multicast) and Hybrid PTP profiles.
The interval is 2
z
seconds, where z= <delay-int-value>.
Table 4-12. PTP
Unicast Dynamic Addressing Mode Parameter Descriptions
Parameter Description
negotiate Use to enable or disable the Grandmasters ability to
dynamically negotiate with clients for IP addresses in Unicast
mode.
lease-duration Sets the maximum duration of the lease for clients that have
dynamically negotiated for IP addresses in Unicast mode.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals