Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 233
Chapter 3
TimeProvider 5000 CLI Command Set
show redundancy
This command displays the IOC redundancy configuration: Port Bonding and IOC
Module.
Command Syntax:
 To display the port redundancy configuration for the specified IOC module:
show redundancy port ioc1
 To display the redundancy port status:
show redundancy active-port
Example 1:
tp5000> show redundancy port ioc1
Response 1:
Port redundancy : enabled
Example 2:
tp5000> show redundancy active-port
Response 2:
IOC active port: eth1
Response 2a:
If redundancy is disabled, the response to this command is:
IOC active port : no active port, redundancy disabled
Level : User, Config, and Admin
set redundancy
Use this command to provision the redundancy configuration for the Ethernet ports
on the IOC module.
Command Syntax:
set redundancy port ioc1 {enable|disable}
set redundancy active-port ioc-[y]
where

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English