098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 295
Chapter 4 Provisioning
Provisioning PTP
PTP Parameters
Unicast (Telecom-20008 and ITU-G.8265.1)
The “set ptp unicast dynamic” command is used to provision parameters specific to
unicast dynamic. See Figure 4-14 for the hierarchy of the “set ptp unicast dynamic”
commands. SeeTable 4-12 for descriptions of the Unicast – Dynamic parameters,
and Table B-31 for defaults and ranges.
The “set ptp unicast static” command is used to provision parameters specific to
unicast static. See Figure 4-15 for the hierarchy of the “set ptp unicast static”
commands. See Table 4-13 for descriptions of the Unicast – Static parameters, and
Table B-31 for defaults and ranges.
The TP5000 can be configured with both dynamically-allocated and static clients at
the same time.
Unicast - Dynamic
The default condition for Unicast negotiate is “Enable”, with a lease duration of 1000
seconds.
Use the following procedure to configure Port 1 of IOC1 for PTP Unicast dynamic
clients, with a lease duration of 250 seconds:
1. Login at the Admin or Config-user level.
2. Type
set ptp profile ioc1-1 telecom-2008 and press Enter.
3. Type
set ptp unicast dynamic negotiate ioc1-1 enable and press Enter.
4. Type
set ptp unicast dynamic lease-duration ioc1-1 250 and press
Enter.
22FF QL-SMC 106 8
30FF QL-DUS 110 9
Others (or absent) Invalid n/a 15
Table 4-9. Option 2 - SSM Mapping to QL and clockClass per G.781 and G.8265-1 (Continued)
Option 2 SSM (hex) Clock QL PTP clockClass PQL