Symmetricom TimeProvider 5000 User Manual

278 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 4 Provisioning
Managing the User Access List
Changing a User’s Access Level
To change a user’s access level you must delete and then re-create the user. This
also provides an opportunity to change the password, if desired. Use the following
procedure to change the access level.
1. Login at the Admin level (see Logging In, on page 275).
2. Type
show user and press Enter to view the current list of users.
3. Type
set user delete <user name> and press Enter.
4. Type
set user add and press TAB twice. The system prompts you for a user
name.
5. Type a user name and press SPACE and then TAB. The name you enter will be
the log-in name for the user. The system prompts you for the access-level for the
user.
6. Type in the desired access-level (user, config, or admin) and press Enter. The
system prompts you for a password.
7. Type a password and press Enter. The password you enter will be the log-in
password for the user. The system responds with the confirm password prompt.
8. Retype the password and press Enter. The system indicates that “
CLI user has
been added: <user>
”.
9. Type
show user and press Enter to verify that the account exists.
10.Repeat Steps 3 through 9 to modify other user access levels.
Note:
User passwords can consist of alphanumeric characters, “~”, “*”, “(“,
“)”, “!”, “?”, “-”, “_”, and “.” with a minimum of 8 characters and a
maximum of 32 characters.
Usernames can consist of numbers, upper and lower case letters,
dash "-", and underscore "_", with a maximum of 20 characters.
Usernames cannot use a leading dash “-” or underscore "_" as the
first character.
For a description of user access levels, see Managing the User
Access List, on page 274.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English