Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 131
Chapter 3
TimeProvider 5000 CLI Command Set
show gnss
This command displays the GNSS port state, priority, position (latitude, longitude,
height), elevation mask value (positioning filter), mode of operation (manual or
automatic), and GPS or Beidou satellite tracking status. It also displays information
for all satellite vehicles being tracked: vehicle number, health, noise ratio, satellite
elevation, satellite azimuth.
Command Syntax:
 To show the GPS configuration on the GNSS port -
show gnss config
 To show the GPS status on the GNSS port -
show gnss status
Example 1:
tp5000>show gnss config
Response 1 :
State - enable
Priority - 1
Mode - auto
GNSS Track-mode - gps
Mask - 10
Antenna Delay - 0
PQL State - disable
PQL Value - 1
GNSS manual position
Latitude - N37:22:42.900
Longitude - W121:55:34.571
Height - 15.4
Example 2:
tp5000>show gnss status
Response 2 :
Current Position Mode - manual
GNSS Status
Current Tracked-GNSS - GPS

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English