Symmetricom TimeProvider 5000 User Manual

158 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show ip
This command displays the Host, Mask, and Gateway IP addresses for Ethernet
interfaces on the specified module. It also indicates if DHCP is enabled and if the
port is enabled.
Command Syntax:
 To show the configuration of the Ethernet interfaces for the specified module
(some settings will only be implemented after restarting the IP interface):
show ip config {imc | ioc1 | exp[0-9]}
 To show the current status of the Ethernet interfaces for the specified module:
show ip status {imc | ioc1 | exp[0-9]} [vlan-id <vlan>]
Defaults:
See Table B-19 for default IP address for the IMC module.
See Table B-25 for default IP address for IOC1 and IOC2 modules.
Example 1:
To display the configuration of the Ethernet interfaces for the IMC module 
tp5000> show ip config imc
Response 1:
MGMT PORT PARAMETERS
IP mode : dhcp
IP state : enable
Example 2:
To display the configuration of the Ethernet interfaces for the IOC1 module 
tp5000> show ip config ioc1
Response 2:
ETH1 PORT PARAMETERS
Note: Packet and byte counts do not include most PTP and NTP
packets.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English