EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #160 background imageLoading...
Page #160 background image
160 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:1920 (1.8 KiB)
ETH2 Link encap:Ethernet HWaddr 00:B0:AE:01:32:4A
inet addr:192.168.2.11 Bcast:192.168.2.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6 errors:0 dropped:0 overruns:0 frame:0
TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:360 (360.0 B) TX bytes:1920 (1.8 KiB)
Level : User, Config, and Admin
set ip
Use this command to provision the Host, Mask, and Gateway IP addresses for IMC
and IOC Ethernet interfaces.
The special value of 0.0.0.0 should be used for the gateway value if a gateway
router is not required.
Command Syntax:
To provision the state of the Ethernet interfaces for the specified module and
port:
set ip {imc|ioc1-1|ioc1-2|exp[0-9] port<1-16>}
[enable|disable|restart]
To set the address, mask and gateway of the Ethernet interfaces for the specified
module and port:
Note: To configure a VLAN, use the command set vlan to provision
the IP addresses.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals