Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 175
Chapter 3
TimeProvider 5000 CLI Command Set
show monitor-exp
Use this command to display the monitor configuration for expansion shelves. If the
monitor in an expansion shelf is enabled, it means that if communication is lost to
this expansion shelf, alarm #0 (communication to peer card failed) will be reported
by the IMC.
Command Syntax:
show monitor-exp
Example:
tp5000> show monitor-exp
Response:
Level : User, Config, and Admin
set monitor-exp
Use this command to specify the monitoring mode for the expansion shelf with
specified ID. If an expansion shelf has monitoring enabled, then a loss of
communication with that expansion shelf will cause an alarm. If an expansion shelf
has monitoring disabled, alarm #0 (communication to peer card failed) will be
cleared, and loss of communication to that shelf will just cause an event.
Command Syntax:
set monitor-exp exp[0-9] {enable | disable}

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English