Symmetricom TimeProvider 5000 User Manual

192 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show output-pps-config
This command displays the System's 1PPS Output Port state, as well as the
provisioned behavior of the 1PPS Output Port during the warm-up, free-run, and
holdover states.
Command Syntax:
show output-pps-config
Example:
tp5000> show output-pps-config
Response:
1PPS output configuration:
Port state - enable
1pps generation warm-up - squelch
1pps generation free-run - squelch
1pps generation fast-track - on
1pps generation holdover - on
Level : User, Config, and Admin
set output-pps
Use this command to provision the System's 1PPS Output Port state. It is also used
to provision the behavior of the 1PPS Output Port during the warm-up, free-run, and
holdover states.
Command Syntax:
 To provision the state of the the 1PPS output port:
set output-pps state [enable|disable]
 To provision the output behavior during the warm-up state:
set output-pps warm-up {on|squelch
 To provision the output behavior during the free-run state:
set output-pps free-run {on|squelch}
 To provision the output behavior during the fast-track state:
set output-pps fast-track {on|squelch}
 To provision the output behavior during the holdover state:
set output-pps holdover {on|squelch}

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English