260 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show vlan-config
Use this command to display the VLAN configuration for a specified service port in
IOC and expansion shelf, including VLAN ID, Index value, priority, state, and Host,
Netmask, and Gateway IP address. This command also can be used to display the
VLAN mode for an IOC port or an expansion shelf.
Command Syntax:
To display the VLAN configuration for the specified port:
show vlan-config {ioc1-1 | ioc1-2 | exp[0-9]}
To display the VLAN mode:
show vlan-mode {ioc1 | exp[0-9]}
Example 1:
To display the VLAN configuration info for port 1 on IOC1 -
tp5000> show vlan-config ioc1-1
Results 1:
Idx VID P StT Address Netmask Gateway/NextHop Destnetwork
1 21 0 en 10.11.11.101 255.255.255.0 10.10.10.1 10.10.10.0/24
2 22 0 en 10.21.21.101 255.255.255.0 20.20.20.1 20.20.20.0/24
3 23 0 en 10.31.31.101 255.255.255.0 30.30.30.1 30.30.30.0/24
4 24 0 en 10.41.41.101 255.255.255.0 40.40.40.1 40.40.40.0/24
5 25 0 en 10.51.51.101 255.255.255.0 50.50.50.1 50.50.50.0/24
6 26 0 en 10.61.61.101 255.255.255.0 60.60.60.1 60.60.60.0/24
7 27 0 en 10.71.71.101 255.255.255.0 70.70.70.1 70.70.70.0/24
8 82 0 en 10.81.81.101 255.255.255.0 80.80.80.1 80.80.80.0/24
9 29 0 en 10.91.91.101 255.255.255.0 90.90.90.1 90.90.90.0/24
10 30 0 en 10.101.101.101 255.255.255.0 100.100.100.1 100.100.100.0/24
11 31 0 en 10.111.111.101 255.255.255.0 10.110.110.1 10.110.110.0/24
12 32 0 en 10.121.121.101 255.255.255.0 10.120.120.1 10.120.120.0/24
13 33 0 en 10.131.131.101 255.255.255.0 10.130.130.1 10.130.130.0/24
14 34 0 en 10.141.141.101 255.255.255.0 10.140.140.1 10.140.140.0/24
15 35 0 en 10.151.151.101 255.255.255.0 10.150.150.1 10.150.150.0/24
16 36 0 en 10.161.161.101 255.255.255.0 10.160.160.1 10.160.160.0/24
Example 2:
To display the VLAN mode info for IOC1
tp5000> show vlan-mode ioc1
Results 2:
VLAN Mode Configuration:
ETH1: enable
ETH2: disable
To Next Page
Loading...
Need help?
General
