EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
98 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show alarm-config
Displays the alarm ID, level, state, description, and reporting delay time for the
TP5000 alarms. This also displays if the alarm is transitory.
Command Syntax:
show alarm-config
Example:
tp5000> show alarm-config
Response :
------------------------------------------------------------------------------
|ID |Level |Delay |State |Descriptions
|----|---------|-------|--------|---------------------------------------------
|0 |critical |0 |enable |Communication to peer card failed
|....|.........|.......|........|.............................................
|1 |minor |0 |enable |GNSS/GPS receiver communications failed
|....|.........|.......|........|.............................................
|2 |minor |0 |enable |GNSS/GPS receiver not tracking satellite
|....|.........|.......|........|.............................................
|3 |major |0 |enable |System time invalid
|....|.........|.......|........|.............................................
|4 |event |0 |enable |System time has been set by reference
|....|.........|.......|........|.............................................
|5 |event |0 |enable |System log time has been updated
|....|.........|.......|........|.............................................
|6 |minor |0 |enable |Management port link down
|....|.........|.......|........|.............................................
|7 |minor |0 |disable |Ethernet port link down
|....|.........|.......|........|.............................................
|8 |minor |0 |enable |Manual sync IOC time to IMC required
|....|.........|.......|........|.............................................
|9 |critical |0 |enable |Power out of range
|....|.........|.......|........|.............................................
|10 |major |0 |enable |GPS antenna voltage out of range
|....|.........|.......|........|.............................................
|11 |major |0 |enable |GPS antenna current out of range
|....|.........|.......|........|.............................................
|12 |minor |0 |enable |GNSS/GPS antenna short-circuit
|....|.........|.......|........|.............................................
|13 |minor |0 |enable |GNSS/GPS antenna open-circuit
|....|.........|.......|........|.............................................
|14 |major |0 |disable |Battery(-48V)-A failure
|....|.........|.......|........|.............................................
|15 |major |0 |disable |Battery(-48V)-B failure
|....|.........|.......|........|.............................................
|16 |critical |0 |enable |FPGA access failure
|....|.........|.......|........|.............................................
|17 |critical |0 |enable |Flash partition failure
|....|.........|.......|........|.............................................
|18 |critical |0 |enable |PLL unlock error
|....|.........|.......|........|.............................................

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals